Are you experiencing a Chevrolet P0156 Code? This code is used to diagnose HO2S-22 (Bank 2 Sensor 2) Circuit Malfunction. The code is triggered when the engine speed is over 1600 rpm in closed loop and stable, ECT sensor is over 158ºF, BARO sensor over 75 kPa, fuel level over 15%, and the PCM detects the average HO2S signal is below 120 mv or over 900 mv, or the HO2S Pullup circuit is over 4.5v for 2 seconds. If you’re encountering this code, there are a few potential causes to consider. This article will discuss the causes of the Chevrolet P0156 Code and the solutions you can use to resolve the issue.
Causes and Solutions for the Chevrolet P0156 Code
| Cause | Solution |
|---|---|
| HO2S signal circuit is open between the sensor and the PCM | Check for any breaks, shorts, or corrosion in the HO2S signal circuit |
| HO2S signal circuit is shorted to sensor or chassis ground | Check the HO2S signal circuit for any shorts to the sensor or chassis ground |
| HO2S signal circuit is shorted to VREF or system power (B+) | Check the HO2S signal circuit for any shorts to the VREF or system power |
| PCM has failed | Replace the PCM if necessary |
HO2S Signal Circuit
The HO2S signal circuit is the cause of many Chevrolet P0156 Code issues. To diagnose any problems with the HO2S signal circuit, you’ll need to perform a visual inspection of the wiring for any breaks, shorts, or corrosion. If you find any of these problems, you’ll need to repair or replace the affected wiring.
HO2S Sensor
The HO2S sensor is another possible cause of the Chevrolet P0156 Code. To diagnose any problems with the HO2S sensor, you’ll need to perform a visual inspection of the sensor for any signs of wear or damage. If you find any signs of wear or damage, you’ll need to replace the sensor.
PCM
The PCM is the final possible cause of the Chevrolet P0156 Code. To diagnose any problems with the PCM, you’ll need to perform a visual inspection of the PCM for any signs of wear or damage. If you find any signs of wear or damage, you’ll need to replace the PCM.
Conclusion
The Chevrolet P0156 Code can be caused by a variety of issues, such as a faulty HO2S signal circuit, a worn or damaged HO2S sensor, and a damaged PCM. If you’re experiencing this code, it’s important to diagnose and repair the issue as soon as possible to prevent further damage to your vehicle. By following the solutions outlined in this article, you can resolve the Chevrolet P0156 Code and get your vehicle back on the road.
https://www.youtube.com/watch?v=VEnAhTN_N_s